Python 6" Racing/ Freestyle Frame

Python 6" Racing/ Freestyle Frame

Designed, developed, and tested in Texas!

Based off the Boa and Cobra SLX Evo frames, the Python 6" racing quadcopter sports a stretched X frame design. The frame is extremely durable, while being easy to work on, and was designed for the ultimate in FPV flying.

EXTREME DURABILITY: The Python utilizes the same CLS (channel lock system) as the Cobra, which captures its 6mm thick arms at 3 different points with one screw, resulting in an extremely durable frame. The CLS plates are located at the front and rear of the frame, and are not connected to the stack in any way. This results in an extremely rigid frame, with no fear of damaging your stack in hard crashes. The stack is mounted to a 2mm thick carbon fiber bottom plate, allowing for a total of 32mm of vertical height to mount your stack. The arms are anchored by the CLS plates, which completely eliminates "arm wiggle", even after continuous crashing. The innovative and extremely durable CLS plate system sets the Python apart from every other frame currently available, by providing the utmost in durability and ease of maintenance.

EASY MAINTENANCE: Arm changes can be done in 60 seconds! The Python's innovative CLS plate design also allows for easy maintenance in the event of a broken arm (broken arms are few and far between). To change an arm, simply remove the screw anchoring the arm to the CLS plate, remove the three motor screws, and slide the arm out.

VERSATILE: With room for 32mm of stack height, the Python has plenty of room for any build imaginable, including lots of LED's!

SMOOTH FLYING: The stretch X design of the Python translates into a smooth flying quadcopter. This is a frame that will make you smile, both during the build and during flight.

Features:

• 3K carbon fiber arms (6mm thick)
  
• 3K carbon fiber bottom plate (2mm thick)
• 3K carbon fiber top plate (2mm thick)
  
• Billet machined aluminum CLS Plates (Channel Lock System)
• Beautifully printed TPU parts (antenna mount, RX antenna tube holder, camera mount)
  
• 12.9 grade steel screws
  
• 16x16 motor mounting
• 258mm wheelbase
• Room for tall stacks - 32mm of usable stack height
  

• Airframe: 91g (including hardware)
• TPU: 11g
  

Includes:

• 4 x 6mm 3K carbon fiber arms
  
• 1 x 2mm 3K carbon fiber bottom plate
• 1 x 2mm 3K carbon fiber top plate
• 2 x Billet machined aluminum CLS Plates
• 1 x TPU camera mount
  
• 1 x TPU antenna mount
• 1 x TPU receiver antenna mount
• 1 x receiver antenna tube with caps
  
• 4 x aluminum black textured 25mm standoffs
• 4 x 3x10mm 12.9 grade steel screws
• 4 x 3x20mm 12.9 grade steel screws
• 2 x 2x6mm camera screws
• 2 x camera screw washers
  

Sky Ready RC BOA Review by Joshua Bardwell