Matek HUBOSD8-SE PDB (184A)

Matek HUBOSD8-SE PDB (184A)

The HUBOSD8-SE has been engineered to provide the highest possible performance and reliability in a 46*36mm & 4 layers PCB. It is a multifunctional HUB with PDB, BEC 5V/1.5A &10V/1.5A, Current sensor 184A, STOSD. It is specially made for the mini FPV Quad. Built-in STOSD8 can support Plug & Play, no complicated settings needed.

Specifications:

• Input: 9~27V (3-6S LiPo)
• Input TVS protection
• Current Rating: 4X30A (Max.4x46A)
• Current sensor 184A
• Built-in STOSD8-SE
• 46x36x4mm, 9g
• Mounting holes 30.5mm Ø3mm

BEC 10V Outputs:

• Designed for Video TX or FPV camera
• Voltage: 10.0 +/- 0.2VDC
• Continuous current: 1.5 Amps (Max.2A 10s/minute)
• Output Ripple: 15mV (VIn=24V, VOut=10V@1.5A load)
• Short-circuit tolerant (2 seconds/minute)
• 10V can be used to power cameras labeled as 12V

BEC 5V Outputs:

• Designed for RC Receivers, Flight controllers, OSD, and Servos
• Voltage: 5.0 +/- 0.1VDC
• Continuous current: 1.5 Amps (Max.2A 10s/minute)
• Output Ripple: 23mV (VIn=24V, VOut=5V@1.5A load) Short-circuit tolerant (2 seconds/minute)

STOSD8:

• Autodetect PAL/NTSC
• Dynamic on-screen info
• Automatic flight timer
• Automatic cell detection
• Low battery alarm
• Exceeding mAh alarm
• Min. voltage & Max. current recorder
• Onscreen Pilot ID
• Upgradeable Firmware
  
• Simple GUI & setting

Downloads:

• HUBOSD8-SE Manual (download the PDF manual here)
• STOSD Tool Software (download the Tool Software here)