Cobra SLX 5" Racing Frame
Cobra SLX 5" Racing Frame
Designed, developed, and tested in Texas!
The ultimate racing frame is now in stock at Sky Ready RC!
The Cobra SLX takes the strength and durability of the original Cobra frame and combines that with a nimble 200mm wheelbase X configuration, weighing in at just 70g with hardware!
EXTREME DURABILITY: The Cobra SLX was created to be the ultimate frame in terms of durability when on a race track. What sets the Cobra SLX apart from other frames is the innovative CLS (channel lock system) which captures the carbon fiber arm at 3 different points with minimal hardware, resulting in a frame with extreme durability. The stack is mounted to a 2mm thick carbon fiber mid plate, allowing rigidity while still preventing the unwanted energy transfer from an aluminum center plate to your stack in a hard crash. Instead of an aluminum center plate bending beyond repair in a hard crash, the carbon fiber mid plate absorbs absorbs crash energy to save your expensive stack. The arms are anchored by the CLS plate in 3 different positions, which completely eliminates "arm wiggle", even after continuous crashing.
EASY MAINTENANCE: Arm changes can be done in 60 seconds! The Cobra SLX's innovative CLS plate design also allows for easy maintenance in the event of a broken arm (broken arms are few and far between). To change an arm, simply remove the screw anchoring the arm to the CLS plate, remove the three motor screws, and slide the arm out.
SHARP CORNERING: The X design of the Cobra SLX translates into equal axis rotation in the air. The 200mm wheelbase allows for super sharp cornering and extreme control in the air. This is a frame that will make you smile both during the build and while flying.
LINK TO ASSEMBLY INSTRUCTIONS: https://www.skyreadyrc.com/store/manuals/cobra_assembly_instructions_v2.pdf
LINK TO OPTIONAL TPU TOP PLATE PROTECTOR AND FIN: https://skyreadyrc.com/store/cobra-slx-top-plate-protector-w-removable-turtle-fin.html
- 3K carbon fiber arms (5mm thick)
- 3K carbon fiber bottom plate (2mm thick)
- 3K carbon fiber mid plate (2mm thick)
- 3K carbon fiber top plate (2mm thick)
- Billet machined aluminum CLS Plates (Channel Lock System)
- Beautifully printed TPU parts (stubby mount, RX antenna tube holder, camera mount)
- 12.9 grade steel screws
- 16x16 motor mounting
- 200mm wheelbase
- Accommodates 20x20 stacks ONLY
- Airframe: 70g (including hardware)
- 4 x 5mm 3K carbon fiber arms
- 1 x 2mm 3K carbon fiber bottom plate
- 1 x 2mm 3K carbon fiber mid plate
- 1 x 2mm 3K carbon fiber top plate
- 2 x Billet machined aluminum CLS Plates
- 1 x TPU camera mount/ protector
- 1 x TPU stubby antenna mount
- 1 x TPU receiver antenna mount
- 1 x receiver antenna tube with caps
- 4 x aluminum black textured 30mm standoffs
- 4 x 3x10mm 12.9 grade steel screws
- 4 x 3x16mm 12.9 grade steel screws
- 2 x 3x6mm 12.9 grade steel screws
- 2 x 2x6mm camera screws
- 2 x camera screw washers