Cobra 5" Racing Frame
- Brand: Sky Ready RC
- Product Code: SRC-COBRA-5
- QTY Remaining: Pre-Order
*** SPECIAL PRE-ORDER PRICE $49.99 ***
Made in Texas!
The Cobra 5" racing quadcopter is a stretch X, light weight, extremely durable, easy to work on airframe designed for high performance FPV Drone Racing.
EXTREME DURABILITY: The Cobra was created to be the ultimate frame in terms of durability when on a race track. What sets the Cobra apart from other frames is the innovative CLS (channel lock system) which captures the carbon fiber arm at 5 different points with minimal hardware, resulting in a frame with extreme durability. The stack is mounted to a 3mm thick carbon fiber bottom plate, allowing an appropriate amount of flex while still preventing the unwanted energy transfer of an aluminum center plate to your stack in a hard crash. Instead of an aluminum center plate bending beyond repair in a hard crash, the carbon fiber bottom plate flexes just enough to save your expensive stack. The CLS plates are located at the front and rear of the frame, and are not anchored to the stack in any way. The arms are anchored by the CLS plate in 5 different positions, which completely eliminates "arm wiggle", even after continuous crashing.
EASY MAINTENANCE: Arm changes can be done in 60 seconds! The Cobra's innovative CLS plate design also allows for easy maintenance in the event of a broken arm (broken arms are few and far between). The Cobra CLS plate was designed specifically around the use of RaceWire Mini, making for even quicker maintenance. To change an arm, simply remove the two screws anchoring the arm to the CLS plate, remove the three motor screws, and slide the arm out. Race wire stays attached to the CLS plate and there is no need to remove it and re-apply it to the new arm!
SHARP CORNERING: The stretch X design of the Cobra translates into a nimble quadcopter in the air. The 223mm wheelbase allows for stable flight, while the stretched X design makes for sharp cornering. This is a frame that will make you smile both during the build and while flying.
- 3K carbon fiber arms (5mm thick)
- 3K carbon fiber bottom plate (3mm thick)
- 3K carbon fiber top plate (2mm thick)
- 6061-T6 Aluminum CLS Plates (Channel Lock System)
- Beautifully printed TPU parts (stubby mount, RX antenna tube holder, camera mount)
- 12.9 grade steel screws
- 16x16 motor mounting
- 223mm wheelbase
- Accommodates 30x30 and 20x20 stacks
- Airframe: 79g (not including TPU parts)
- 4 x 5mm 3K carbon fiber arms
- 1 x 3mm 3K carbon fiber bottom plate
- 1 x 2mm 3K carbon fiber top plate
- 2 x 6061-T6 aluminum CLS Plates
- 1 x TPU Camera mount/ protector
- 1 x TPU stubby antenna mount
- 1 x TPU receiver antenna mount
- 1 x receiver antenna tube
- 4 x aluminum black textured 25mm standoffs
- 8 x 3x10mm 12.9 grade steel screws
- 4 x 3x16mm 12.9 grade steel screws
- 1 x Lumenier 20mmx250mm Kevlar battery strap